DeLonghi DINAMICA PLUS ECAM37 95 Series Instructions For Use Manual page 27

PROBLEM
Coffee does not come out of one or
both spouts.
The coffee delivered is watery.
The appliance will not make coffee
The appliance does not come on
The infuser cannot be removed
At the end of descaling, the appliance
requests a third rinse
Milk does not flow from the milk
spout (E5)
The milk contains large bubbles and
squirts out of the milk spout (E5) or
there is little froth
The machine emits noises or small
puffs of steam while not in use
The app is not working
POSSIBLE CAUSE
The coffee spouts (A9) are blocked.
The funnel (A4) is clogged.
The appliance has detected impurities
in its internal circuits. "Cleaning under-
way" is displayed.
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The appliance has not been turned off
correctly
During the two rinse cycles, the water
tank (A17) has not been filled to the
MAX level
The milk container lid (E2) (E3) is dirty
The lid (E2) is not correctly in place.
The milk is not cold enough or not suit-
able for the beverage requested.
The froth adjustment dial (E1) is incor-
rectly adjusted.
The milk container lid (E2) or froth ad-
justment dial (E1) are dirty
There is water in the groove below the
froth adjustment dial (E1)
Vegetable beverages have been used.
The hot water connection nozzle (A8)
is dirty
The machine is ready for use, or has re-
cently been turned off, and condensate
is dripping into the hot vaporiser
App malfunction
27
REMEDY
Clean the spouts with a toothpick (fig. 24B).
Clean the funnel with the help of the brush
(D5) as described in section "13.8 Cleaning the
pre-ground coffee funnel".
Wait for the appliance to be ready again and
reselect the required beverage. Contact cus-
tomer services if the problem persists.
Turn the appliance off by pressing the
ton (A15) (see section "5. Turning the appliance
off").
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A15) to avoid
the water overflowing.
Clean the milk carafe lid as described in section
"13.10 Cleaning the milk container".
Assemble all the components correctly as indi-
cated in section "9.1 Filling and attaching the
milk container".
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in section "9.
making cappuccinos and milk-based beverag-
es ".
Clean the milk container lid and control knob
as described in section "13.10 Cleaning the
milk container".
Extract the dial and dry thoroughly.
For best results, use beverages at refrigerator
temperature (about 5° C). Adjust the amount
of froth as described in section "9.2 Adjusting
the amount of froth"
Clean the connection nozzle as described in
section "13.11 Cleaning the hot water nozzle".
This is part of normal operation. To limit the
phenomenon, empty the drip tray.
Close the App, then run it again
but-