Dynaudio Studio Series User Manual page 26

With the Speaker Unit connected to the speaker cable it can be inserted into the Installation Frame. Turn the
locking tabs on the front surface of the Speaker Unit fully clockwise (aligned with the lock icons) and insert it in the
Installation Frame. Push gently around each locking tab until a click is heard. The Speaker Unit will then be
secured in the frame.
Note
Take care that the cable is positioned in such a way that it will not get trapped as the Speaker Unit is secured
into the Installation Frame and is not touching the Speaker Unit in such a manner that it is likely to result in
audible vibrations.
Note
To remove the Speaker Unit from the Installation Frame turn the locking tabs 90° counter-clockwise. Take care
to support the speaker as the locking tabs are turned.
Note
Studio Series wall speakers are intended to be installed with the tweeter above the bass/mid driver.
The high frequency tonal balance of the Studio Series speakers can be adjusted to suit different installation
environments. A tweeter level switch located on the Speaker Unit front panel offers +3 dB, 0 dB and -3 dB
options. The level adjustment operates from approximately 3 kHz upwards.
Note
The +3 dB tweeter level option may be appropriate if, for example, carpets, soft furnishings and curtains
dominate in the listening environment. Alternatively the -3 dB option may be more suited to an environment
where hard floors and glass predominate. In more balanced acoustic environments, the 0 dB option is likely to
be most appropriate.
With the speaker connected and secured into the Installation Frame, in-wall speaker installation is completed by
fitting the grille. The grille is secured magnetically and requires no more than placing into position.
Note
If the wall is to be painted following speaker installation, the supplied paint mask must be used to protect the
speaker hardware from paint ingress. Speaker grilles should not be fitted during painting. They should be
26 Studio Series User manual