Dynaudio Studio Series User Manual page 25

Note
If speaker cables are not already installed it should be done at this stage. It is possible that access will be
required through the opposite side of the wall to route the cables. Use low resistance speaker cable with clear
polarity marking on its insulation. Low resistance is especially important if the length of cable from amplifier to
speaker exceeds 5 m. Your local Dynaudio retailer or distributor will be able to offer advice on speaker cable
selection if required.
Pull the speaker cable through the Installation Frame and wall cut-out. The length of free cable should be sufficient
to allow the Speaker Unit to be held in one hand while connecting the cable to the Speaker Unit terminals with the
other hand.
The speaker cable can now be connected to the speaker. Strip 15 mm insulation from the cable (if necessary),
twist the wire strands and insert the stripped ends into the speaker spring terminals. Ensure that the positive
conductor is connected to the red speaker terminal and the negative conductor is connected to the black speaker
terminal.
In-wall Speaker Installation 25