Dynaudio Studio Series User Manual page 22

Hide thumbs Also See for Studio Series:

[1] Rotate speaker to adjust bass/mid driver directivity

[2] Switch to adjust tweeter level

[3] Push to click. Three locations. Rotate clockwise to lock. Rotate counter-clockwise to release.

[4] Tilt to adjust tweeter directivity

Note

Take care that the speaker cable is positioned in such a way that it will not get trapped as the Speaker Unit is

secured into the Installation Frame and is not touching the Speaker Unit in such a manner that it is likely to

result in audible vibrations.

Note

To remove the Speaker Unit from the Installation Frame turn the locking tabs 90° counter-clockwise. Take care

to support the speaker as the locking tabs are released.

With the speaker connected and secured into the Installation Frame, its bass/mid driver orientation and tweeter

angle can be adjusted. In most installations, the orientation and angle should be adjusted so that the drivers face

towards the listening position. To adjust the bass/mid driver orientation, grip the tweeter mounting arm and rotate

the entire Speaker Unit as necessary. To adjust the tweeter tilt, grip the tweeter body and angle it to one of the

three positions.

The high frequency tonal balance of Studio Series speakers can be adjusted to suit different installation

environments. A tweeter level switch located on the front bezel offers +3 dB, 0 dB and -3 dB options on the

S4-C65 or S4-C80, and 0 dB dB or -3 dB options on the S4-DVC65.

Note

Different tweeter levels may be appropriate to suit different listening environments. An environment dominated

by carpets, soft furnishings and curtains for example might require a higher tweeter level than an environment

where tiled floors and glass predominate.

In-ceiling speaker installation is completed by fitting the grille. The grille is secured magnetically and requires no

more than placing into position.

Note

Square Studio Series in-ceiling speaker grilles are optionally available. Magnetic attachment enables square

grilles to be rotated as required to align perfectly with ceiling or wall lines.

Note

If the ceiling is to be painted following speaker installation, the supplied paint mask must be used to protect the

speaker hardware from paint ingress. Speaker grilles should not be fitted during painting. They should be

painted separately.

Studio Series User manual

Table of Contents