In-Ceiling Speaker Installation - Dynaudio Studio Series User Manual

Hide thumbs Also See for Studio Series:

In-ceiling Speaker Installation

Note

These installation instructions broadly assume that speaker cables are pre-installed in ceilings and walls.

To install a Studio Series in-ceiling speaker, proceed as described in the following paragraphs and accompanying

diagrams:

Having selected the installation position and checked for the presence of studs (joists), pipe work, ducts or

cables, mark a cut-line on the ceiling using the supplied template. Check that the diameter of the cut-line is

correct: 210 mm (8

Use an appropriate tool to cut along the cut-line to create a cut-out in the ceiling. Trial fit the speaker Installation

Frame in the cut-out to check clearances.

Note

The orientation of the Installation Frame within the cut-out is inconsequential.

Note

If using a pre-construction ring, follow the instructions in the pre-construction document.

Note

In order to reduce the possibility of audible ceiling vibration it may be prudent to apply a bead of adhesive

mastic between the ceiling joists and the drywall (plasterboard) in the vicinity of in-ceiling speakers.

With the ceiling cut-out checked, the Installation Frame can be installed. Lift the frame into place and while holding

it against the ceiling with one hand use the other hand to turn the three yellow securing clamps outwards and

slide them down against the inner surface of the drywall (plasterboard).

In-ceiling Speaker Installation

⁄

in) for the S4-C65 and S4-DVC65, and 260 mm (10

⁄

in) for the S4-C80.

Table of Contents