In-Wall Speaker Installation - Dynaudio Studio Series User Manual

Hide thumbs Also See for Studio Series:

In-wall Speaker Installation

To install a Studio Series in-wall speaker, proceed as described in the following paragraphs and accompanying

diagrams:

Having selected the installation position and checked for the presence of studs (joists), pipe work, ducts or

cables, mark a portrait orientation cut-line on the wall using the supplied template. Check that the dimensions of

the cut-line are correct: 175 x 275 mm (6

the S4-W80.

Note

Studio Series in-wall speakers are intended to be used in portrait orientation.

Use an appropriate tool to cut along the cut-line to create a cut-out in the wall. Trial fit the speaker Installation

Frame in the cut-out to check clearances.

Note

In order to reduce the possibility of audible wall vibration it may be prudent to apply a bead of adhesive mastic

between the wall studs and the drywall (plasterboard) in the vicinity of wall speakers.

With the cut-out checked, the Installation Frame can be installed. Insert the frame into place and while holding it

against the wall with one hand use the other hand to turn and slide the four yellow securing clamps outwards and

slide them down against the inner surface of the drywall (plasterboard).

In-wall Speaker Installation

⁄

x 101

⁄

in) for the S4-W65 and 215 x 370 mm (8

⁄

x 14

⁄

in) for

Table of Contents