Routes; Create A Route - Lowrance 100 Installation And Operation Instructions Manual

Waypoint Options
You can customize the method used to show a user
waypoint on the map screens. To do this, first press the
MENU key, then select "MAP SETUP", finally select
"WAYPOINT OPTIONS". The screen shown at right ap-
pears. You can turn all of the waypoints, their symbols,
names, or numbers on or off. Simply select the desired
label, then press the appropriate arrow key. Press the
EXIT key to erase this menu.

ROUTES

You can connect several waypoints (user or aviation) together to form a
route. When you recall the route, the unit shows navigation information to
the first waypoint in the route, then when you reach that waypoint, it
switches to the next waypoint, and so on until you reach the last waypoint
in the route.

Create a Route

To create a route, first press the MENU key, highlight
the "ROUTE PLANNING" label, and press the right
arrow key. The screen shown at right appears.
This unit can store up to 99 routes. Route number one
shows on this page. If you wish to create a route using
a different number, simply press the left or right arrow
keys until the desired route number appears. In this
example, however, we'll use route number one.
If you wish to name the route, highlight the "EDIT NAME"
label and press the right arrow key. Use the arrow keys to name the route,
(you can use up to eight characters in the name) then press the ENT key
when you're finished.
The gray boxes in the lower half of the screen com-
prise the list of waypoints that form the route. To add
waypoints to the route, highlight the first gray box in the
middle of the screen and press the right arrow key. The
screen shown at right appears. To add a waypoint to
the route from the waypoint table, select the "ADD WPT"
label. The screen shown at the left on the next page
appears.
51