Graco Reactor 3 E-XP1 Operation page 30

Startup
11. Turn on the air compressor, air dryer, and
breathing air (if applicable).
12. For the first startup of new system, use the
transfer pumps to supply fluid to the system.
a. Check that all Setup
See Setup, page
b. If If If an an agitator an agitator is is is used agitator
agitator on. See your agitator manual,
Related Manuals, page 3
c. If If If you you need you need to to to circulate need
system to preheat the drum supply, see
system system
Circulation Through Reactor, page
If If If you you need you need need to to to circulate
the the heated the heated heated hose hose to to to the hose
see Circulation Through Gun Manifold,
page 37.
d. Turn both pressure relief/spray valves
(SA, SB) to spray
e. Open the fluid inlet valves (XA and XB).
Check for leaks.
30
Setup steps are complete.
Setup
25.
used, turn the used
.
circulate fluid circulate fluid fluid through through the through
36.
circulate material circulate material through material through through
the the gun gun manifold gun manifold, manifold
.
Cross-contamination can result
in cured material in fluid lines
which could cause serious injury
or damage equipment. To prevent
cross-contamination:
• Never interchange component A and
component B wetted parts.
• Never use solvent on one side if it
has been contaminated from the
other side.
• Always provide two grounded waste
containers to keep component A and
component B fluids separate.
f. Turn on the transfer pumps.
If If If you you are
you
pump: pump: on the ADM screen, tap pump:
the the
to turn on the A-side transfer pump and
pump.
If If If you you are
you
pump: pump: see your pump manual, pump:
Related Manuals, page 3
g. Hold the gun fluid manifold over two
grounded waste containers. Open fluid
valves A and B until clean, air-free fluid
comes from valves. Close valves.
The Fusion AP gun manifold is shown.
are using using an an electric electric transfer
are using an electric
to turn on the B-side transfer
are using using a a a pneumatic pneumatic transfer
are using pneumatic
.
transfer
transfer
transfer
transfer
3A8500E