Graco Reactor 3 E-XP1 Operation page 12

Warnings
EQUIPMENT MISUSE
EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest
rated system component. See Technical
• Use fluids and solvents that are compatible with equipment wetted parts. See
Technical Specifications in all equipment manuals. Read fluid and solvent
manufacturer's warnings. For complete information about your material, request
Safety Data Sheets (SDSs) from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure
is not in use.
• Check equipment daily. Repair or replace worn or damaged parts immediately with
genuine manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency
approvals and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are
using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and
hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
MOVING PARTS
MOVING MOVING
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Equipment can start without warning. Before checking, moving, or servicing
equipment, follow the Pressure
BURN BURN BURN HAZARD HAZARD HAZARD
Equipment surfaces and fluid that is heated can become very hot during operation.
To avoid severe burns:
• Do not touch hot fluid or equipment.
12
WARNING
WARNING WARNING
MISUSE HAZARD HAZARD
MISUSE HAZARD
PARTS HAZARD HAZARD
PARTS HAZARD
Pressure Relief
Pressure
Technical Specifications Specifications in all equipment manuals.
Technical Specifications
Pressure Relief Pressure Relief Procedure Relief
Relief Procedure Procedure and disconnect all power sources.
Relief Procedure
Procedure when equipment Procedure
3A8500E