Online Mode
Online Program Change
9.2
Where complete networks are to be added or removed, the "Online Program Change" operation
must be used. This method is the preferred method of making changes to the program whilst
on-line. For example: If the recently added counter network is to be removed from the program,
carry out the following procedure (Remember the PLC and GX IEC Developer programs must
be identical before proceeding).
Highlight network 3 on the POU body "MOTOR_CONTROL" and press "Delete" on the key-
board.
Invoke the Online Program Change feature from the Project
Menu. GX IEC Developer will compile and write the online change
automatically.
Training Manual GX IEC Developer
Online Program Change
9 - 3