Error Codes 6701 To 6710 - Mitsubishi Electric FX Series Training Manual

Appendix
A.3.4

Error codes 6701 to 6710

Error
Operation error
*
Even if the syntax or circuit design is correct, an operation error may still occur. For example: "T200Z" itself is not an
error. But if Z had a value of 400, the timer T600 would be attempted to be accessed. This would cause an operation
error since there is no T600 device available.
Training Manual GX IEC Developer
Special Error
Description
Register Code
0000 No error
No jump destination (pointer) for CJ
or CALL instruction
Label is undefined or out of P0 to
P4095 due to indexing
6701
Label P63 is executed in CALL
instruction; cannot be used in CALL
instruction as P63 is for jumping to
END instruction.
CALL instruction nesting level is 6 or
6702
more
6703
Interrupt nesting level is 3 or more
FOR-NEXT instruction nesting level is 6
6704
or more.
Operand of applied instruction is inap-
6705
plicable device.
Device number range or data value for
6706
operand of applied instruction exceeds
limit.
D8067
File register is accessed without para-
6707
meter setting of file register.
6708
FROM/TO instruction error
6709
Other (e.g. improper branching)
6710 Mismatch among parameters
Error Code List
Corrective Action
—
This error occurs in the exe-
cution of operation. Review
the program, or check the
contents of the operands
used in the applied
instructions.*
This error occurs in the exe-
cution of operation. Review
the program, or check the
contents of the operands
used in the applied instruc-
tions. Check whether the
specified buffer memories
exist in the equipment.
Check whether the extension
cables are correctly
connected.
This error occurs in the exe-
cution of operation. Review
the program, or check the
contents of the operands
used in the applied
instructions.*
This error occurs when the
same device is used within
the source and destination in
a shift instruction, etc.
A - 13