Data Types
3.4.3
MELSEC Timers and Counters
When programming standard Timers/Counters, an IEC convention must be observed:
Timer/Counter Coil is programmed:
Timer/Counter Contact is programmed:
Timer/Counter Value is programmed:
In the following example T0 becomes TC0 and TS0. In this case Mitsubishi addresses have
been used, it is therefore vital to check the System Variable default T/C usage:
In the following example, the counter has been programmed using identifiers which would have
to be declared in the Global and Local Variable tables:
3 - 20
TCn / CCn
TSn / CSn
TNn / CNn
MITSUBISHI ELECTRIC
Programming