Omron sysmac EtherNet/IP NJ Series Connection Manual page 25

7.3.2. Setting up the EtherCAT Network Configuration
Set up the EtherCAT network configuration.
The slave unit may perform unexpected operation when you power cycle it in
step 6.
Always confirm safety before you power cycle the slave unit.
1
Right-click Master on the
EtherCAT Tab Page of the Edit
Pane, and select Write Slave
Node Address.
*If the EtherCAT Tab Page is not
displayed in the Edit Pane, take
step 9 in 7.3.1. Starting
Sysmac Studio and Installing
the ESI Files to display.
A screen is displayed stating
"Get information is being
executed".
2
The Slave Node Address Writing
Dialog Box is displayed.
UR20-FBC-EC
Rev:0x00000001 is displayed in
the Actual network
configuration.
3
Enter 1 as a node address in the
Set value Column.
7．EtherCAT Connection Procedure
22