Omron sysmac EtherNet/IP NJ Series Connection Manual page 21

5
The Connect to Device Dialog
Box is displayed.
Select Direct connection via
USB in the Connection type
Field.
Uncheck both Transfer from
Device and Display the
Troubleshooting Dialog Box in
the Operation after Connection
Field.
Click Connect.
6
A confirmation dialog box is
displayed. Check the contents
and click OK.
*The contents of the dialog box
vary depending on the status of
Controller. Check the contents
and click on an appropriate
button to proceed with the
processing.
7
The dialog box on the right is
displayed. Check the contents
and click OK.
8
The Auto Connect Project
Dialog Box is displayed online.
When an online connection is
established, a yellow bar is
displayed under the toolbar.
The following panes are
displayed in this window.
Left: Multiview Explorer
Top right: Toolbox
Bottom right: Controller Status Pane
Top middle: Edit Pane
The following tabs are displayed
in the bottom middle of this
window.
Output Tab Page
Build Tab Page
7．EtherCAT Connection Procedure
Multiview
Edit Pane
Explorer
Output Tab Build Tab
Page
Page
Toolbox
Controller
Status
Pane
18