Lexmark S815 User Manual page 159

R
ECONNECT THE POWER SUPPLY
1
Turn off the printer.
Note: Make sure the printer is not in Power Saver mode. Press and hold
2
Pull out the power cord from the power supply.
3
After a minute, reconnect the power cord into the power supply.
4
Turn on the printer.
T
RY RUNNING THE INSTALLER AGAIN
1
Close the installer.
2
Remove the CD, and then restart the computer.
3
Insert the installation software CD and then run the installer again.
Notes:
•
When you get to the Software Already Installed screen, make sure you select Install a new printer.
•
If you have already set up your printer, then select Change Connection to skip the hardware setup wizard.
C
HECK THAT YOUR COMPUTER IS ABLE TO ACKNOWLEDGE
Open the Device Manager to check if it has activity whenever a USB device is connected to a USB port:
1
Click , or click Start and then click Run.
2
In the Start Search or Run box, type devmgmt.msc.
3
Press Enter, or click OK.
USB
Troubleshooting
159
for three seconds to turn off the printer.
USB
ACTIVITY ON THE PORT