Lexmark Pro915 User Manual page 85

From here
Dialing and Sending
Fax Blocking
Configuring fax settings using the fax software
Before you begin, make sure that:
• The printer is properly connected to the telephone line.
• The printer is turned on and connected to the computer.
• The printer is not in Sleep mode. If the printer is in Sleep mode, then press
Using the Fax Setup Wizard in Windows
1
Click or Start.
2
Click All Programs or Programs, and then select the printer program folder from the list.
3
Click Printer Home > Fax > Set up the printer to fax.
The Fax Setup Wizard opens.
4
Run the Fax Setup Wizard. Make sure you select the correct telephone service and connection. The wizard
configures optimal fax settings based on your connection.
Note: If you want to configure the advanced fax settings, then from the Printer Home, click Fax > Configure the
advanced fax settings. This launches the Printer Setup Utility.
Using the Printer Settings in Macintosh
1
From the Applications folder in the Finder, or from the Finder desktop, double-click the printer folder.
2
Double-click Printer Settings.
3
Configure the fax settings using the printer software.
To view the help information for the fax software, click Help or .
You can
•
Set your fax name and fax number.
•
Adjust the dialing volume.
•
Set the dial method, redial time, number of redial attempts,
dialing prefix, and fax sending speed.
• Convert sent faxes into modes that receiving fax machines
recognize. Otherwise, such faxes are aborted.
• Enable error correction during transmission.
•
Set whether the printer scans the original document before or
after dialing the recipient.
Set the printer to scan before dialing so that you do not have
to scan the document again if the fax fails. The scanned
document is saved in the printer memory. The printer can then
retrieve it and automatically redial the number.
If you set the printer to scan after dialing, then the printer
does not automatically redial, even when the phone line is
busy.
Block unwanted incoming faxes.
Faxing
85
to wake up the printer.