Table of Contents
Advertisement
Installation Procedure
Step 2 Choosing the installation location
General requirements for installation location
Do not install the air conditioner in a location where it will come
into contact with the following elements:
• Combustible gases
• Saline air
• Machine oil
• Sulphide gas
• Special environmental conditions
Avoid installing the air conditioner in a location with the
following conditions:
• In areas where it is exposed to direct sunlight. Close to heat
sources.
• In damp areas or locations where it could come into contact
with water. (for example rooms used for laundry)
• In areas where curtains and furniture could affect the supply
and discharge of air.
• Without leaving the required minimum space around the
unit. (as shown in the drawing)
• In scarcely ventilated areas.
• On surfaces that are unable to support the weight of the unit
without deforming, breaking or causing vibrations during the
use of the air conditioner.
• In a position that does not enable the condensate drainage
pipe to be correctly installed. (at the end of the installation.
It is always essential to check the efficiency of the drainage
system)
6
English
Indoor unit installation requirement
• This unit has to be installed as floor type only.
• There must be no obstacles near the air inlet and outlet.
• Select a convenient location that permits the air to reach
every corner of the area to be cooled.
• Pre-plan for easy and short routing of the refrigerant tubing
and wiring to the outdoor unit.
• There should be no flammable gas, alkaline, substances
present in the air.
• Maintain sufficient clearance around the indoor unit.
• Make sure that the water dripping from the drain hose runs
away correctly and safely.
• Do not install the unit where it will be exposed to direct
sunlight.
CAUTION
• Our units should be installed in compliance with the spaces
shown in the installation manual, to ensure accessibility from
both sides and allow repairs or maintenance operations to be
carried out. The unit's components should be accessible and
easy to disassemble without endangering people and objects.
• For this reason, when provisions of the installation manual
are not complied with, the cost required to access and repair
the units (in SAFETY CONDITIONS, as set out in prevailing
regulations) with harnesses, ladders, scaffolding or any other
elevation system will NOT be considered part of the warranty
and will be charged to the end customer.
A
A : 11.81 inch (300mm) or more
B : 39.37 inch (1000mm) or more
A
B
Advertisement
Table of Contents
