Table of Contents
Advertisement
QoS Config
On this page, you can enable QoS and set the DSCP Mark
The maximum number of queues that can be configured vary by mode, as shown below.
Mode
Maximum # of queues
ATM
16
Ethernet
4 per interface
PTM
8
1. In the left navigation bar, click
2. If the
Enable QoS
checkbox is not checked, click it to select it.
Warning: If this option is already enabled and you clear the checkbox, QoS will be disabled for ALL interfaces.
3. In the
Select Default DSCP Mark
used. The default is No Change(-1). For a list of supported values, see
4. Click
Apply/Save
to save your settings.
Supported DSCP Values
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
classification.
Advanced Setup
>
Quality Of Service
field, select the Differentiated Services Code Point (DSCP) Mark classification value to be
>
QoS
Config. The following page appears.
"Supported DSCP
Values".
67
Advertisement
Table of Contents
