Table of Contents
Advertisement
1. In the left navigation bar, click
2. Fill in the fields, using the information in the table below.
3. Click
Apply/Save
to commit your changes.
The fields on this page are explained in the following table.
Field Name
Description
Policy Name
Enter a descriptive name for this entry to the policy routing table.
Source IP
Enter the IP address for the source of this policy route.
Use Interface
Select the WAN Interface for this policy route.
Default Gateway IP
Enter the IP address of the default gateway.
RIP (Routing Information Protocol)
RIP is a type of distance-vector routing protocol, which leverages hop count as a metric for routing. RIP puts a limit on the number of
hops (maximum of 15) allowed in order to prevent routing loops. This can sometimes limit the size of networks where RIP can be suc-
cessfully employed.
Note: This feature applies only to IPoE configurations.
On this page, you can configure the RIP settings.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
Advanced Setup
>
Routing
>
Policy Routing
and then click Add. The following page appears.
76
Advertisement
Table of Contents
