Table of Contents
Advertisement
Field Name
Launch Dhcp6c for
Address Assignment
(IANA)
Launch Dhcp6c for Pre-
fix Delegation (APD)
Retry PPP password
on authentication
error
Enable PPP Debug
Mode
Bridge PPPoE Frames
Between WAN and
Local Ports
Enable Firewall
Enable SYN Flood
rules
Network Address Translation Settings
Enable NAT
Enable Fullcone NAT
Enable SIP ALG
IGMP Multicast
section
Enable IGMP Multicast
Proxy
Enable IGMP Multicast
Source
MLD Multicast
section
Enable MLD Multicast
Proxy
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
Description
( Available only when IPv4&IPv6 (Dual Stack) is selected for the
Select to launch the dhcp6c client deamon to request and configure IPv6 addresses and
host network configuration information.
( Available only when IPv4&IPv6 (Dual Stack) is selected for the
Select to enable your DHCPv6 server to allow your gateway to ask for an IPv6 prefix (sub-
net) that it can then split up and delegate to the clients it serves. This option is selected
by default.
This option is selected by default. To disable it, click the checkbox to clear it.
In the
Max PPP authentication retries
tication retries on failure. Options are 1 - 65536. Entering 65536 sets the maximum to
unlimited.
Select to have the system put more PPP connection information into the system log of the
device. This is for debugging errors and not for normal usage.
Select to enable PPPoE passthrough to relay PPPoE connections from behind the modem.
Also known as Half-Bridged mode.
This option is selected by default and enables functions in the
able the firewall, click the checkbox to clear it.
Select to enable rules for preventing SYN flood distributed denial of service attacks.
section
Select to enable sharing the WAN interface across multiple devices on the LAN. Additional
NAT and PPPoE NAT features appear.
(Appears when
Enable NAT
(Appears when
Enable NAT
pass-through NAT. Used for Voice over IP (VOIP) applications.
Click to enable Internet Group Membership Protocol (IGMP) multicast. Used by IPv4 hosts
to report multicast group memberships to any neighboring multicast routers.
Select to enable this service to act as an IGMP multicast source.
(Available only for IPv6 environments) Click to enable MLD multicast. Used by IPv4 hosts to
report multicast group memberships to any neighboring multicast routers.
field, enter the maximum number of PPP authen-
is selected) Click to enable what is known as one-to-one NAT.
is selected) Click to enable Session Initiation Protocol (SIP)
Internet Protocol
field )
Internet Protocol
field )
Security
sub-menu. To dis-
32
Advertisement
Table of Contents
