Connection Details - Singtel Ras - Leviton 47611-GT4 User Manual

Internet Gateway User Guide
Connection Log
•
Connection Log
•
Buttons
If not connected, establish a connection to Telstra Big Pond.
Connect
Disconnect If connected to Telstra Big Pond, terminate the connection.
Clear Log Delete all data currently in the Log. This will make it easier to read
new messages.
Refresh Update the data on screen.

Connection Details - SingTel RAS

If using the SingTel RAS access method, a screen like the following example will be displayed
when the "Connection Details" button is clicked.
Data - RAS Screen
Internet
RAS Plan The RAS Plan which is currently used.
Physical Address The hardware address of this device, as seen by remote devices on
the Internet. (This is different to the hardware address seen by
devices on the local LAN.)
IP Address The IP Address of this device, as seen by Internet users. This address
is allocated by your ISP (Internet Service Provider).
The Network Mask associated with the IP Address above.
Network Mask
The Connection Log shows status messages relating to the
existing connection.
The Clear Log button will restart the Log, while the Refresh
button will update the messages shown on screen.
Figure 25: Connection Details - RAS
38