Customizing Data Display - GE Dash 3000 Operator's Manual

Interfacing with Non-GE Devices

Customizing Data Display

Default Parameter Alarm Levels
Alarm Limits
Parameter Windows and Menus
Peripheral Device Monitoring Guidelines
Anesthesia Interface
E-16
Configure all alarm levels on the monitor. When connected to a monitor, the
connectivity device follows the alarm levels defined in the MONITOR DEFAULTS
menu. The peripheral device does not determine the alarm level displayed or
broadcast by the monitor.
Refer to the following table for the monitor's factory default parameter alarm levels.
CRISIS
VENT
SVO2
TC
CCO
ICG
You must configure all alarm limits on the monitor. The monitor only displays and
enunciates the alarm limit violations defined on the peripheral device.
The parameters displayed by the monitor from a peripheral device vary from device
to device. Anesthesia machines, parameter modules, gas analyzers and ventilators are
capable of sending parameters to the monitor. In some cases, not all parameters can be
displayed at one time.
To add parameters to the display, use the following procedure.
1. Select MONITOR SETUP.
2. Select PARAMETERS ON/OFF. All parameters sent to the monitor display in
the AVAILABLE PARAMETERS information window.
3. Select the parameters you want to display.
4. Select RETURN to close the window.
When an anesthesia interface is connected, the following applies:
The monitor can display up to three parameters: CO
The information displayed varies by device.
Dash™ 3000/4000/5000
WARNING ADVISORY
X
X
X
, GAS and Vent.
2
MESSAGE
X
X
2000966-386D