Viewing The Tire Pressures; Resetting Tire Pressure Monitoring System - Ford TRANSIT 2022 Owner's Manual

Tire Pressure Monitoring System
VIEWING THE TIRE
PRESSURES
E250820
To view the current tire pressures, use the
information display or touchscreen.
RESETTING TIRE PRESSURE
MONITORING SYSTEM
Tire Pressure Monitoring System
Reset Procedure
WARNING: To determine the
required pressure(s) for your vehicle, see
the Safety Compliance Certification
Label (on the door hinge pillar,
door-latch post or the door edge that
meets the door-latch post, next to the
driver seat) or the Tire Label on the
B-Pillar or the edge of the driver door.
You must reset the tire pressure monitoring
system after each tire rotation on vehicles
that require different recommended tire
pressures in the front tires as compared to
the rear tires.
2022 Transit (TTH) Canada/United States of America, NK3J 19A321 AA enUSA, Edition date: 202107, First-Printing
Note: To reduce the chances of interference
from another vehicle, perform the system
reset procedure at least three feet, one
meter, away from another vehicle
undergoing the system reset procedure at
the same time.
Note: Do not wait more than two minutes
between resetting each tire sensor or the
system can time-out and you need to repeat
the entire procedure on all four wheels.
1. Drive the vehicle above 20 mph
(32 km/h) for at least two minutes,
then park in a safe location where you
can easily get to all four tires and have
access to an air pump.
2. Switch the ignition off.
3. Switch the ignition on but do not start
the engine.
4. Switch the hazard flashers on then off
three times.
Note: You must accomplish this within 10
seconds. If you successfully enter the reset
mode, the horn sounds once, the system
indicator flashes and a message shows in
the information display.
Note: If the system does not enter reset
mode, try again starting at Step 2. If after
repeated attempts to enter the reset mode,
the horn does not sound, the system
indicator does not flash and no message
shows in the information display, contact
your authorized dealer.
5. Remove the valve cap from the valve
stem on the left front tire. Decrease the
air pressure until the horn sounds.
Note: The single horn tone confirms that
the sensor identification code has been
learned by the module for this position. If
the horn sounds twice, the reset procedure
was unsuccessful, and you must repeat it.
6. Remove the valve cap from the valve
stem on the right front tire. Decrease
the air pressure until the horn sounds.
428
(If Equipped)