Engine Cooling Fan - 3.5L Duratec/3.5L Ecoboost - Ford TRANSIT 2022 Owner's Manual

3. Release the clamps that secure the air
filter cover to the air filter housing.
E174669
4. Carefully lift the air filter housing cover.
Remove the air filter element from the
air filter housing.
ENGINE AIR FILTER - INFORMATION MESSAGES
Message
Filter OK
Check Filter See Manual
System Fault See Manual
ENGINE COOLING FAN - 3.5L
DURATEC/3.5L ECOBOOST
WARNING: Keep your hands and
clothing clear of the engine cooling fan.
2022 Transit (TTH) Canada/United States of America, NK3J 19A321 AA enUSA, Edition date: 202107, First-Printing
Maintenance
5. Install a new air filter element.
6. Replace the air filter housing cover.
7.
8. Reconnect the intake air temperature
Indicates the engine air filter is performing as expected.
Indicates that there is a higher than expected restriction
across the engine air filter, which could represent an air filter
at full useful life or a filter with an obstruction.
When this displays, inspect the engine air filter and replace
After the inspection or engine air filter replacement, you must
reset the system in order to change the status from Check
Indicates that there is an error within the electronic air filter
maintenance minder system requiring service.
Under certain conditions, the engine
cooling fan may continue to run for several
minutes after you switch your vehicle off.
381
Engage the clamps that secure the air
filter housing cover to the air filter
housing. Be careful not to crimp the
filter element edges between the air
filter housing and cover. Make sure
that the tabs on the edge are correctly
aligned into the slots.
Slip the air tube onto the air filter cover
and firmly tighten the bolt on the air
tube clamp, but do not overtighten.
sensor electrical connector to the
outlet tube. Make sure the locking tab
on the connector is in the locked
position.
Action
if necessary.
Filter to Filter OK.