Installation Location Requirements - Siemens SITRANS F MASS 2100 Operating Instructions Manual

Installing/mounting
4.1 Basic safety notes
Exceeded maximum permissible operating pressure
Risk of injury or poisoning.
The maximum permissible operating pressure depends on the device version, pressure limit
and temperature rating. The device can be damaged if the operating pressure is exceeded. Hot,
toxic and corrosive process media could be released.
Ensure that maximum permissible operating pressure of the device is not exceeded. Refer to
the information on the nameplate and/or in Technical data (Page 107).
Incorrect mounting at Zone 0
Risk of explosion in hazardous areas.
• Ensure sufficient tightness at the process connection.
• Observe the standard IEC/EN 60079-14.
Loss of explosion protection
Risk of explosion in hazardous areas if the device is open or not properly closed.
• Close the device as described in Installing/mounting (Page 27).
External stresses and loads
Damage to device by severe external stresses and loads (e.g. thermal expansion or pipe
tension). Process media can be released.
• Prevent severe external stresses and loads from acting on the device.
4.1.1

Installation location requirements

NOTICE
Strong vibrations
Damage to device.
• In installations with strong vibrations, mount the transmitter in a low vibration
28
WARNING
WARNING
WARNING
CAUTION
environment.
SITRANS MASS 2100 & FC300 (FCT010/DSL)
Operating Instructions, 06/2020, A5E39788682-AB