Table of Contents
Advertisement
HP processor probe—At a Glance
The HP processor probe provides a
low-cost way to debug embedded
software for IBM/Motorola PowerPC™
microprocessors.
Supported processors
Your HP processor probe is
pre-programmed for either the
PowerPC 603 or PowerPC 603e
processor.
The floppy disk contains firmware to
program your HP processor probe for
additional PowerPC processors.
The target connection
The HP processor probe connects to
your target microprocessor via a
special connector on the target system.
The configuration switches
Use the switches to configure
communication to the HP 16505A. There
is a guide to these switches on the
bottom of the HP processor probe.
ii
The status LEDs
LEDs show the status of the power
supply, the target system, and the
connection to the LAN.
Compatibility with other products
The HP processor probe requires the
use of a host based software debugger.
No debuggers for the HP processor
probe are sold by Hewlett-Packard so
you must purchase a software
debugger from a third party.
Advertisement
Table of Contents
