Table of Contents
Advertisement
TEST 5: Target Probe Feedback Test
A verbose output on this test can be extensive. For example, the following is
the output of this test if you forget to plug in the E3490-61604 connector.
p>pv -t5 -v2 1
Testing: HPE3499A Series Emulation System
Test # 5: Target Probe Feedback Test
Bad 20 Pin Status Read when unconnected = 0x7fb7
Bad 20 Pin Status Read when connected= 7fb7
Output 19 Low not received on Input 11
Output 11 Low not received on Input 19
Output 13 Low not received on Input 1
Output 12 High not received on Input 6
Output 12 and Input 6 not pulled high on release
Output 8 Low not received on Input 10
Output 7 Low not received on Input 20
Output 4 Low not received on Input 14
Output 2 Low not received on Input 18
FAILED
Number of tests: 1
If the you get a verbose output like this, check to make sure that the self test
loopback connector was connected properly.
To execute the built-in performance verification test
Expected Value = 0xffb7
Expected Value = 0x7fb7
Number of failures: 1
Solving Problems
failed!
91
Advertisement
Table of Contents
