Table of Contents
Advertisement
PowerPC is checkstopped
PowerPC is in an unknown state
Only the boot ROM was used; other firmware in the Flash EPROM has
been corrupted
Starting a user interface will change the pattern to the one requested
by the interface.
If the power up self tests fail, try the following:
Check and reset the LAN address as shown in the "Connecting to the
Host Computer chapter. LAN powerup failures will occur if the
HP processor probe does not have a valid Link Level Address and IP
Address.
Disconnect all external connections, including the LAN, serial (RS-232),
and BNC Break and Trigger cables, then cycle power.
To ensure that the firmware is working as it should, reprogram the
firmware, then cycle power.
Solving Problems
To run the power up self test
85
Advertisement
Table of Contents
