Table of Contents
Advertisement
Wait at least 20 seconds for the HP processor probe to connect to the
4
LAN.
Become the root user on the system from which you wish to
5
configure the HP processor probe.
Enter the following command:
6
ipconfig700 -l <link> -i <internet> [-g <gateway>]
The ipconfig700 parameters are:
The link-level address. Enter any letters in the address in upper case.
-l <link>
The IP address.
-i <internet>
The gateway address.
-g <gateway>
If the ipconfig700 command is entered without any options, the program
interactively prompts for the necessary information.
Set switch S6 back to CLOSED.
7
Verify your HP processor probe is now active and on the network.
8
See "To verify LAN communications" on page 20.
Example
If the link-level address on your HP processor probe read 08000F090F30, and
your system administrator gave you the IP address 192.35.12.6, you could
enter the following command:
$ ipconfig700 -l 08000F090B30 -i 192.35.12.6 <RETURN>
Because no gateway address was entered, this value would default to 0.0.0.0.
When the IP address is successfully programmed, ipconfig700 will display the
HP processor probe version information.
Connecting to the Host Computer
To configure LAN parameters using "ipconfig700"
15
Advertisement
Table of Contents
