HP E3494A Installation And Service Manual page 20

Connecting to the Host Computer
To configure LAN parameters using the built-in terminal interface
The gateway address. Setting the gateway address allows access outside
-g <gateway>
your local network or subnet.
This changes the base TCP service port number.
-p <port>
The default numbers (6470, 6471) can be changed if they conflict with some
other product on your network. TCP service port numbers must be greater
than 1024. If you change the base port, the new value must also be entered in
the /etc/services file on the host computer. For example, you could add or
modify the line:
hp64700 6470/tcp
Disconnect the power cord from the HP processor probe, and
6
connect the the HP processor probe to your network.
This connection can be made by using either the 10BASE-T connector or the
10BASE2 (BNC) connector on the HP processor probe. Do not use both
connectors at the same time.
Set the configuration switches to indicate the type of connection that
7
is to be made.
Switch S1 must be set to OPEN, indicating that a LAN connection is being
made.
Switch S5 should be 1 if you are connecting to the BNC connector:
Switch S5 should be 0 if you are connecting to the 10BASE-T connector:
Set all other switches to CLOSED.
Connect the power cord to the HP processor probe.
8
Verify your HP processor probe is now active and on the network.
9
See "To verify LAN communications" on page 20.
12