Using The Countdown Timer - Yaesu FTM-400XDR/DE Operating Manual

The lap time measured in the past will be displayed
when [RECALL] is touched. When there are multiple
lap times, touch [] or [] to switch between the lap
times.
6
Touch briefly twice
The display will return to the previous screen.
• Touch [RECALL] when the previous lap times are being displayed and then turn
Tips
• The screen will change in the following sequence each time
altitude display screen and GPS screen are "ON".
Normal frequency display → Compass/Lat&Lon display screen → Altitude display screen →
Timer/Clock screen → GPS screen
Using the countdown timer
1
Display the timer / clock screen
2
Touch [MODE] twice
The countdown timer will be displayed.
3
Touch [SETUP]
The "Hour" of the start time will blink.
4
Turn to set the hour
Tips • The hour can be set between 00 and 99.
• The time can also be set by touching [+] or [-].
5
Touch [SETUP]
The "Hour" will be set, and "Minute" will blink.
6
Turn to set the minute
Tip The time can also be set by touching [+] or [-].
Using the Timer Function
is pressed when both the
twice.
121