Download Print this page

NCR SelfServ 90 Kit Instructions

Mei tricolor and trilight cable

Hide thumbs Also See for SelfServ 90:

Download this manual

KIT INSTRUCTIONS

NCR SelfServ™ 90 (7709)

MEI Tricolor and Trilight Cable

7709-K901

Issue A

Page 1 KIT INSTRUCTIONS NCR SelfServ™ 90 (7709) MEI Tricolor and Trilight Cable 7709-K901 Issue A...
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
Page 3 SS90 MEI Tricolor and Trilight Cable Introduction This kit provides ten MEI Tricolor and Trilight cables. Kit Contents...
Page 4: Installation Procedure
SS90 MEI Tricolor and Trilight Cable Installation Procedure Warning: Disconnect the AC power cord before disassembling the Terminal. 1. Access the I/O Box in the rear side of the Kiosk Pedestal and disconnect the R6 Tri-Light extension cable from the I/O Box port, TRILIGHT/LANELIGHT. 2.
Page 5 SS90 MEI Tricolor and Trilight Cable 3. Connect the TRILIGHT connector of the MEI Tricolor and Trilight cable to the R6 Tri-Light extension cable. 4. From inside the SS90 Cabinet, route the SS90 Tri-Color LED cable down into the pedestal through the left-hand access hole.
Page 6 SS90 MEI Tricolor and Trilight Cable 5. Connect the SS90 Tri-Color LED cable to the MEI TRICOLOR connector of the MEI Tricolor and Trilight cable. 6. Bundle and secure the excess cable length inside the pedestal.

7709