Advertisement
Quick Links
Advertisement
Related Manuals for NCR POS XR8
Summary of Contents for NCR POS XR8
- Page 1 Serial Cables, Dual NCR POS XR8 (7607) 7607-K495 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Contents
Serial Cables, Dual This kit provides a two Serial Cables for the NCR POS XR8 (7607). Kit Contents Item Part Number Description 497-0508746 Cable, RS232, Panel Mount 006-8613209 Screw, Standoff, #4 – 40 x .187 x .462, Hex, Male/Female, with Slot, Nickel... -
Page 4: Installation Procedure
Serial Cables, Dual Installation Procedure Warning: Disconnect the power cable before disassembling the terminal. 1. Turn the key clockwise and pull down the Front Bezel Plate to remove it from the terminal case. 2. Remove the Top Cover. a. Loosen the two thumbscrews connecting the Top Cover to the terminal. b. - Page 5 Serial Cables, Dual 3. Remove the Hard Drive Tray. a. Loosen the thumbscrew and slide the Hard Drive Tray back to disengage the hooks. b. Gently lift the Tray from the terminal case.
- Page 6 Serial Cables, Dual 4. Move the Tray toward the LED board side of the terminal case and place back down on the case. 5. Remove the Daughter Card. a. Disconnect the power supply connector from the Daughter Card.
- Page 7 Serial Cables, Dual b. Unscrew the Daughter Card from the sled on the ports side of the sled. c. Slide the Daughter Card sideways from the riser card until it detaches.
- Page 8 Serial Cables, Dual d. Push the Daughter Card slightly back until the bracket clears the edge of the sled and gently lift the Card from the sled. 6. Install the Serial Cables on the inside of the chassis (2 hex standoff screws per Serial Cable).
- Page 9 Serial Cables, Dual 7. Connect the Cables to the Motherboard. Ensure to connect the respective cables to the correct ports as shown below. Push the excess Serial Cable down below the height of the heatsink to provide clearance when the Daughter Card is reinstalled. 8.