NCR SelfServ 90 Instructions Manual
Security scale counter top
Hide thumbs
Also See for SelfServ 90:
- Instructions manual (12 pages) ,
- Kit instructions (8 pages) ,
- Kit instructions (5 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for NCR SelfServ 90
Summary of Contents for NCR SelfServ 90
- Page 1 Kit Instructions SelfServ™ 90 Security Scale Counter Top 7709-K710 Issue B...
- Page 2 NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Software screen images are representative, and in some cases, may not match a customer’s installed software exactly.
- Page 3 Revision Record Issue Date Remarks Apr 2016 First Issue Sep 2019 Added the minimum and maximum capacity of the scale with bagrack...
-
Page 5: Kit Contents
Security Scale Counter Top Introduction This kit provides the components to install a security scale integrated to the NCR SelfServ™ 90 Kiosk. The following table shows the minimum and maximum capacity of the scale with bagrack. pound (lb) kilogram (kg) Minimum allowable weight 0.040... -
Page 6: Mounting Holes
Security Scale Counter Top Mounting Holes Four (4) mounting holes at the base plate provides the option to anchor and secure the Counter Top Scale in position. The mounting hole dimensions are shown in the illustration below. The anchors used to bolt the security scale are customer supplied. Note: Before bolting the scale, make sure that the scale is properly level, adjust the leveling mounts as necessary. -
Page 7: Installation Procedure
Security Scale Counter Top Installation Procedure The Counter Top Security Scale can be anchored to the counter top to secure the scale. If the scale will be anchored to the counter top, refer to the "Bolting the Security Scale page 5" section in this instruction sheet and perform the procedure. If not, perform the steps below to install the scale. - Page 8 Security Scale Counter Top 4. Inside the cabinet, route the cable towards the motherboard and plug the connector to the USB D USB+12V power port. Cable tie the cable with other cables as necessary. 5. Place and secure the excess cable length outside of the Kiosk Cabinet. 6.
- Page 9 Security Scale Counter Top Bolting the Security Scale 1. Remove the screws (4) that secures the bagrack to the base assembly and remove the bagrack. 2. Remove the screws (4) that secure the top plate to the base assembly and remove the top plate.
- Page 10 Security Scale Counter Top 3. Position the base assembly on its installation location and adjust the level mounts (4) as necessary until the base is level. 4. Mark the anchor holes of the base on the counter top. Refer to the "Mounting Holes on page 2"...
- Page 11 Security Scale Counter Top 7. Mount the top plate on the base assembly and secure with screws (4). Tighten the screws just enough to secure the top plate, preferably about 0.68 N.m (6 lbf.in) to 0.90 N.m (8 lbf.in) using a torque screw. Do NOT overtighten. 8.
- Page 12 Security Scale Counter Top 9. Route the Security Scale USB Cable into the Kiosk cabinet through the rear access hole. 10. Inside the cabinet, route the cable towards the motherboard and plug the connector to the USB D USB+12V power port. Cable tie the cable with other cables as necessary.
- Page 13 Security Scale Counter Top 11. Check that all the modules in the kiosk are functioning properly. Make sure that the security scale is level, adjust the leveling mounts as necessary.