Introduction This kit provides one RS‐232 connector w/harness and one PS/2 connector w/harness for the 7610/7611 Connector Panel. Note: The RS‐232 cable cannot be installed if an Integrated 2x20 Customer Display is present. Both devices use the internal RS232/D header. Screw, Standoff, 4-4- x 0.187 x 0.462, Hex RS-232 Panel Mount Cable 006-8613209 497-0468839 PS/2 Gasket 497-0470544 PS/2 Panel Mount Cable 497-0466593 29408 Installation Procedures Warning: Disconnect the power before disassembling the Terminal. 1. Disconnect the Power Cable. The Power Cable connector locks into position when connected to the terminal and cannot be removed by simply pulling on the cable. You must grasp the connector and slide the outside housing out from the terminal to unlock it from the terminal connector to remove it. 29249a ...
Page 4
2. Remove the Table Top Stand. a. Lay the terminal face down on a flat surface. Caution: The front bezel is a painted component and the weight of the terminal can cause abrasions when moved around on a surface. Always use a soft material (cloth, foam) to protect the bezel when placing the terminal face down. b. Loosen the captive thumbscrews (2) that secure the Table Top Stand. Protective Foam or Cloth 29241a c. Slide the Table Top Stand as shown to disengage the slots in the Table Top Stand from the Mounting Studs on the back of the terminal. Mounting Slots Mounting Studs 29239a...
Page 5
3. Remove the Rear Cover (loosen the captive screws (4) that secure it to the chassis.) Captive Screws 29287 Installing the RS-232 Port 4. Remove the RS232/D knockout from the Connector Panel. Insert a flat screwdriver in the slot and twist the knockout up and down to break it loose. RS-232/D Knockout 29409...
Page 6
5. Install the RS‐232 Connector on the Connector Panel (2 hex screws). 29418 6. Connect the RS‐232 Cable to COMD on the Motherboard. COMD 29419...
Page 7
7. Set the COMD jumper to 12 V powered. Ring Indicator 12 V * Default setting COMD 29420...
Page 8
Installing the PS/2 Port 8. Remove the PS/2 knockout from the Connector Panel. Insert a flat screwdriver in the slot and twist the knockout up and down to break it loose. PS/2 Knockout 29412 9. Remove the hex nut from the PS/2 Connector. 29413...
Page 9
10. Route the PS/2 Cable through the Connector Panel from the outside of the terminal. Insert PS/2 Gasket and hex nut onto the cable. Note the orientation of the extensions on the gasket (away from the connector). Hex Nut PS/2 Gasket 29415 11. Align the PS/2 Connector and Gasket properly with the keyed hole in the Connector Panel and then secure the connector with the hex nut. 29416...
Page 10
12. Connect the PS/2 Cable to the PS/2 Connector on the Motherboard. PS/2 Connector 29417 13. Replace the Rear Cover (4 captive screws). 29292 14. Replace the Display Head on the Table Top Stand.. ...