Accessories
6.1 DC link adapter
6.1.5.1
Opening the protective flap and removing the DC link screws
Required tools:
• Flat bladed screwdriver (1 x 5.5) for releasing the protective flap
Table 6-2
Opening the protective flap and removing the DC link screws
1 x 5,5
1. Release and open the protective flap.
4. Remove the upper and lower right-
hand DC link screw.
6.1.5.2
43 A DC link adapter (6SL3162-2BD00-0AA0)
If you are using the DC link adapter to supply several components, then you must install it on the
component to the far right.
78
T20
2. Remove the upper left-hand screw
and the DC link bridge
3. Remove the lower left-hand screw and
the DC link bridge
To install the DC link adapter, it is essen‐
tial to leave the DC link busbars
②
in the component (hold firmly to pre‐
vent them falling out).
Equipment Manual, 01/2022, 6SL3097-6AC30-0BP0
①
and
Booksize power units