Install The Rack Rails And Server Tray - HP ProLiant ML30 Gen10 Plus User Manual

Install the rack rails and server tray

Install the rack rails and server tray
The rack rails can be installed in a round-hole or a square-hole racks. The rack rails occupy 1U space in the rack.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Disassemble the rack rail assemblies:
a. Pull out the inner sliding rail until it is fully extended.
b. Slide and hold the white release tab in the direction shown, and then remove the sliding rail from the mounting rail.
2. Install the sliding rails on the server tray:
a. Insert the spools on the sides of the server through the notches on the rails.
b. Slide the rail towards the rear of the tray to lock it into place.
Install the rack rails and server tray 73