Table of Contents
Advertisement
WARNING
The sealant is hazardous to heath. Remove immediately if it comes into
■
contact with the skin.
Observe the manufacturer's usage instructions for the breakdown kit.
■
For the sake of the environment
Used sealant or sealant whose expiry date has passed must be disposed of in
accordance with environmental protection regulations.
Note
A new bottle of sealant can be purchased from ŠKODA Original Parts.
■
Immediately replace the wheel that was repaired using the breakdown kit or
■
consult a specialist garage about repair possibilities.
Components of the puncture repair kit
Fig. 165 Principle sketch: Repair kit components
Read and observe
on page 174 first.
Components of the set
» Fig. 165
Sticker with "max. 80 km/h"/"max. 50 mph" speed designation
1
Valve remover
2
Inflation hose with plug
3
Air compressor
4
Button for releasing the tyre pressure
5
12 volt cable connector
6
174
Do-it-yourself
All manuals and user guides at all-guides.com
7
8
9
10
11
The valve remover
The kit is located in a box under the floor covering in the luggage compart-
ment. It contains a sealant and an air compressor.
Note
The declaration of conformity is included with the air compressor or the log
folder.
General information
For your own safety and the safety of your passengers, the following instruc-
tions must be observed before carrying out a wheel repair on the road.
The national legal requirements must be observed when repairing a tyre.
The breakdown kit must not be used under the following circumstances.
›
The rim is damaged.
›
The outside temperature is below -20 ° C.
›
The cut or puncture is larger than 4 mm.
›
The tyre wall is damaged.
›
The result will be to drive with very low tyre pressure or with a completely
flat tyres.
›
After the expiration date (see inflation bottle).
Tyre inflation hose
Tyre pressure indicator
ON and OFF switch
Tyre inflator bottle with sealant
Replacement valve core
has a slot at its lower end which fits into the valve core.
2
Read and observe
on page 174 first.
Switch on the hazard warning lights system.
The warning triangle must be set up at the prescribed distance - observe
the national legal provisions when doing so.
Park the vehicle as far away as possible from the flow of traffic.
Choose a location with a flat, solid surface.
Have all the passengers get out. The passengers should not stand on the
road (instead they should remain behind a crash barrier, for instance) while
the wheel is being changed.
Advertisement
Chapters
Table of Contents
