Table of Contents
Advertisement
For information about the compatibility of phones/tablets, please refer to the
■
websites at www.skoda-auto.com.
ŠKODA accepts no responsibility for any problems caused by incompatibility
■
or improper functioning of the phones/tablets and the applications on them.
Connection with SmartGate
Read and observe
and
on page 100 first.
For a successful connection the following conditions must be met.
Wi-Fi is turned on in the device to be connected.
The ignition is switched on.
Connect
›
Can enable the connected device to search for available Wi-Fi networks (see
operating instructions for the connected device).
›
In the found networks menu, select the connection to the
"SmartGate_ ... "network
.
1)
›
Enter the password (the password is preset at the factory to the complete
Vehicle Identification Number - enter capital letters).
Disconnecting the connection
The connection to SmartGate can be ended in the following ways.
›
By disconnecting the connected device from SmartGate.
›
By turning off the Wi-Fi in the connected device.
›
By switching off the ignition and removing the key for more than 5 s (for ve-
hicles with starter button - by turning off the engine and opening the driver's
door).
Automatic connection
The connection to SmarttGate is automatically restored under the following
conditions.
Wi-Fi is turned on in the device to be connected.
The ignition is switched on.
The device to be connected stores the password required for the connec-
tion check.
1)
The last six symbols of the VIN vehicle identification number of your vehicle are displayed at position ....
All manuals and user guides at all-guides.com
Connection problems
If the connection fails, check the following points.
›
›
›
›
›
If the above items are ok but the connection still fails, contact a ŠKODA part-
ner.
Smart Gate website
There is a special website for the SmartGate system.
The following address must be entered in the web browser of the connected
device.
This website contains information about the vehicle, the Wi-Fi connection and
SmartGate.
In the Configuration area the Wi-Fi connection settings can be adjusted.
Save the setting changes
The setting changes are only applied after performing the following steps.
›
›
Password Management
Password management can be done in the connected device on the Smart-
Gate
The changes are applied after saving and restarting SmartGate
Save the setting changes.
Are the conditions for a successful connection fulfilled?
Is Smart Gate available in the list of available Wi-Fi networks?
Has the password required for the connection check been entered?
Is the password is required for the connection check correct?
Is the device to be connected still connected to another Wi-Fi network?
Read and observe
and
on page 100 first.
HTTP://192.168.123.1
The changes are saved by pressing the "Save" button.
SmartGate is restarted by pressing the "Reboot "button.
Read and observe
and
on page 100 first.
website» page
101, Smart Gate website.
» page
101,
101
Communication
Advertisement
Chapters
Table of Contents
