Maytag Amana PMH Series Service And Troubleshooting page 24

SYSTEM OPERATION
first unoccupied setback time.
6. To select second unoccupied setback temperature,
press the HEAT
either the up or down arrow
unoccupied setback temperature.
Cooling example: 720 (guest set point) + 40 (Setback
temperature) = 760 (operational set point).
7. Press HEAT key to scroll to
cupied setback time. Press either the up or down arrow
to the desired second unoccupied setback time.
Example: Operating set point would be 760 instead of
72, one hour (1.0 hour) after guest leaves room.
8. Press HEAT key to scroll to
pied setback temperature. Press either the up or down
arrow to the desired third unoccupied setback
temperature.
9. Press HEAT
key to scroll to
pied setback time. Press either the up or down arrow
to the desired third unoccupied setback time.
10. To exit configuration mode:
Press the OFF
ture mode will also automatically exit if no keys are
pressed for a period of two (2) minutes.
The changes made in configuration mode are now in
effect.
NOTE: Additional codes are present and may be accessed
within this menu. Contact the manufacturer for additional
information.
key until comes up. Press
to the desired second
second unoc-
third unoccu-
third unoccu-
key. NOTE: Configuration fea-
Configuration Settings
7 Button Touch Pad with Display
The control can be configured to operate a wide range of
options. The options listed below with the * are the factory
default settings. If these are acceptable, then the unit does
not require any additional configuration and is fully oper-
able. To configure the unit, first select the configuration
feature code setting and then an option code to change
from the factory default setting.
To enter configuration feature mode:
1. Press and hold the up and down
same time and press the OFF
two (2) second time frame. The display will indicate - -.,
and then release the
one time. The display will then alternate between C1
and 0.
To select a different configuration feature code, press
the HEAT key until the desired configuration
comes up. To scroll to a previously viewed configura-
tion codes press the COOL
scrolled to the correct feature, then to select the option
code for your desired configuration, press either the up
or down key to scroll through the options of the
selected feature code.
To exit configuration mode:
1. Press the OFF
will also exit if no keys are pressed for a period of two
(2) minutes.
Refer to the Configuration Chart on page 25.
arrow keys at the
key twice within a
key and press the
key.Once you have
key. Configuration feature mode
key
24