Maytag Amana PMH Series Service And Troubleshooting page 16

SYSTEM OPERATION
possible and as far to the right as possible in a location
that will not interfere with the reinstallation of the PTAC
polymer room front. Mark holes for screw location.
Remove antenna housing and drill two 1/8" holes where
marked. Some units may have the holes already pre-
drilled in the correct location.
Wire
DT01* Mounting
5. Remove antenna cable and route cable through open-
ing in bottom of antenna housing.
6. Mount antenna housing with two screws as shown in
figure. (NOTE: The Amana® brand logo should be in
the lower right hand corner).
7. Plug wire harness from antenna into connector on the
control board to the right of the master switch, being
careful not to bend and/or break the wires when you
connect the cable to the PTAC. Gently push the con-
nector into place by pushing on the edge of the connec-
tor with your thumb nails. Avoid pushing directly on the
wires.
8. Restore power to the PTAC unit.
9. Reinstall the polymer room cover.
NOTE: The LED must be oriented at the top of the antenna
housing (the Amana® brand logo will be on the lower right)
for proper unit operation.
Wireless Thermostat
NOTE: A DT01* must be installed on the digital PTAC unit
for the DS01* to be operable.
Skip these steps if not installing.
1. Select thermostat mounting location about five feet
above the floor, on an inside wall, out of direct sunlight,
away from sources of radiant heat (lamps, fireplaces,
heating and air conditioning equipment, etc.), away from
windows or door to the outside, and avoid areas with
poor air circulation. If the PIR in the thermostat is to be
used with a DD01* device as a 2nd motion sensor, point
the thermostat towards the area where you are requiring
additional motion sensing. Ensure location is out of the
path of foot traffic where a person might accidentally
bump into the thermostats and damage the device.
2. Remove thermostat from mounting plate by pulling apart
at the bottom of the thermostat about 1", and slide ther-
mostat up to release from the top of the mounting plate.
3. Place thermostat mounting plate against the wall at
desired location and mark placement of mounting holes.
Make sure the UP arrow is pointing up on the mounting
plate.
4. If mounting in drywall, tap plastic anchors into wall. For
other surfaces, drill a 3/16" hole.
5. Screw mounting plate to the wall. DO NOT SNAP
THERMOSTAT INTO PLACE UNTIL AFTER BINDING
PROCESS. See Binding Instructions.
6. Install four (4) AA batteries (included) into the back of
the thermostat. Terminals are marked "+" and "-" for
polarity.
NOTE: Do not install thermostat on wall plate until all
configuration settings and binding processes have been
completed.
Wired Power Option
1. If the option for wired power is used, the two thermostat
wires (20 gauge minimum field supplied) can be con-
nected to the thermostat.
2. Route wires through the opening in the mounting plate.
3. Loosen set screws on wired terminal and insert wires
into the opening. Tighten set screws.
4. Connect wires at PTAC unit to terminal pins C and R.
The wire harness kit PWHK01C is required for this
connection.
TWO JUMPERS
FACTORY DEFAULT
"BATTERY"
BATTERY CONNECTION
NOTE: For battery connection the 2 jumpers must be posi-
tioned as shown above, with jumpers on the center & left.
16