Maytag Amana PMH Series Service And Troubleshooting page 11

SPECIFICATIONS
Electric
No. of
Voltage Heater Size
Stages
(kW)
230/208V 2.5
230/208V 3.5
230/208V 5
265V 2.5
265V 3.7
265V 5
Notes:
¹ All 265-volt models must use an Amana® brand sub-base (PTSB4**E) or an Amana® brand hard-wire kit (PTPWHWK4).
² Minimum branch circuit ampacity ratings conform to the National Electric Code; however, local codes should apply.
³ Minimum voltage on 230/208-volt models is 197 volts; maximum is 253 volts.
Minimum voltage on 265-volt models is 239 volts; maximum is 292 volts.
4
Overcurrent protection for all units without electric heaters is 15 amps. Overcurrent protection on 265-volt models must be cartridge-style time-delay fuses (included
and factory-installed on all Amana® brand 265-volt chassis).
5
Heating capacity and efficiency based on unit operation without condensate pump.
6
Total watts for 15,000 BTU/h models; subtract 20 watts for PT07/09/12
7
Specify two-digit heater kW size to complete model number.
8
R-410A refrigerant used in all systems.
9
All units meet or exceed ASHRAE 90.1 standards.
10
All units less than 250 volts have a Leak Current Detector Interrupter (LCDI) power cord and meet UL 484 standards.
Nominal Heating (BTU/h)
@ 230V @ 208V @ 265V
1 8,500 6,800
1 12,000 9,900
1 17,100 14,000
1 - - - - 8,500
1 - - - - 12,600
1 - - - - 17,100
Total
Total
6
Amps
Watts
- - 2,570 / 2,115 11.2 / 10.1
- - 3,570 / 2,935 15.5 / 14.1
- - 5,070 / 4,160 22.1 / 20.0
2,570 9.7
3,770 14.2
5,070 19.2
PTH G SERIES
HEH H SERIES
PMH & PMC SERIES
4
Min. Circuit
MOD
Power Cord
Ampacity²
(amps)
14.1 15 6-15 P
19.5 20 6-20 P
27.6 30 6-30 P
12.2 15 7-20 P
17.9 20 7-20 P
23.9 25 7-30 P
EER - Energy Efficiency Ratio per The Air-Conditioning, Heating, and
Refrigeration Institute (AHRI) Test Procedures and Canadian
Standards Association (CSA) Test Procedures.
COP - Coefficient of Performance per AHRI Test Procedures
11