Maytag Amana PMH Series Service And Troubleshooting page 22

SYSTEM OPERATION
NOTE: Both the DS01E and the DD01E must be bound
to the PTAC unit during the same "learn"
operation.
If you need to rebind one device - then you
must rebind both devices during the same
learn mode event.
All must be bound at one time.
1. Press and hold OFF button on the PTAC until
pears.
2. Press and then immediately release the white tactile
button on the back of the DS01* thermostat.
should now be displayed on the PTAC LED display. If
does not show on the display in 1-2 seconds, then
press and release the white button a second time. Skip
this step if there is no thermostat.
3. Press and then immediately release the white tactile
button on the back of the DD01* motion sensor.
or should now be displayed on the PTAC LED
display.
If or does not show on the display in 1-2
seconds, then press and release the white button a sec-
ond time. NOTE: If both a DD01* and a DS01* are being
bound, then the display will show
Skip if there is no motion sensor.
4. Press "OFF" on the PTAC touchpad to exit the binding
sequence.
5. Slide top of the thermostat down onto the wall plate and
then snap into place.
6. Provided optional security screws may be used in lower
corners of the thermostat.
7. Snap motion sensor onto motion sensor mounting plate.
ap- 8. Provided optional security screws may be installed on
right and left side of the sensor.
9. If you wish to change from the factory default settings,
configure the device or devices that were bound. See
the next section for configuration choices.
NOTE: If a wireless device is replaced or added, all
devices (including those previously bound) will need to
be bound/re-bound to the unit. See directions above.
Entering Room Number (Skip if not using DP01* Front
Desk Platform)
1. The PTAC control can be set for a 4-digit room num-
ber. To select the first two digits (floor), press the HEAT
down
. 2. To select the last two digits of the room number, press
the HEAT
up and down
room number.
For example for Room "201", press the HEAT
key until
Next to select the last two digits of the room number,
OPTIONAL
SECURITY SCREWS
key until appears, then press the up and
arrows to select the first two digits.
key until
arrows to select the last 2 digits of the
appears, then press the up and down
arrows to select "02":
appears, then press the
= .
22