If One Of These Messages Is Displayed - Kyocera Scanner/Plotter System (E) Operation Manual

If One of These Messages is Displayed...

There are cases when one of the following messages may appear in the message display. After verifying the message, perform the appropriate
procedure as indicated below. Refer as well to the Operation Guide for your copier for more information on the proper procedure to follow.
Message
Place paper in drawer.
Memory full
Add toner.
Check waste toner tank.
Paper misfeed.
Set original again
Remove original.
Time for Maintenance
Call service.
The drawer has run out of paper. Set a new paper roll.
The memory in the copier has reached its capacity during scanning and no more documents can be
scanned. Select either "Discharge to front" or "Discharge to back" as the document eject method and
then press the Enter key. The image data for the document currently being scanned will be deleted.
If this message appears often, increase the memory in the copier.
Toner has run low. Refer to the Operation Guide for your copier and replenish the toner.
The waste toner tank is full. Refer to the Operation Guide for your copier and replace the waste toner
tank with a new one.
Paper has jammed. Refer to the Operation Guide for your copier and perform the procedure as
indicated in the message display.
The document has jammed. Remove the jammed document and insert it once again into the document
table.
The document has jammed after scanning was completed. Remove the jammed document.
The time for periodic maintenance has arrived. Contact your service representative, an authorized
service center or the place of purchase.
Trouble has occurred within the copier/Scanner/Plotter System(E).
Refer to the "If a Service Call Message Appears" section of the Operation Guide for your copier.
Chapter 4 Troubleshooting
Procedure
4-3