Procedures; Connecting The Copier To Your Network; Network Settings [Configuring The Ip Address, Etc.] - Kyocera Scanner/Plotter System (E) Operation Manual

Chapter 2 Set-Up (Copier)

Procedures

Connecting the Copier to Your Network

Perform this procedure in order to connect a copier with the Scanner/
Plotter System(E) installed to a network hub.
1 Turn the main switch to the copier OFF (
CAUTION
Make sure the main switch is OFF (
network cable.
2 Plug the network cable into the Network Interface Connector
which is located on the left of the copier.
3 Plug the other end of the network cable into the network
hub.
4
Turn the main switch to the copier back ON ( | ).
2-2
).
) before connecting the

Network Settings [Configuring the IP Address, etc.]

Perform this procedure in order to register the required network
settings in the copier that has the Scanner/Plotter System(E)
installed.
NOTES
• The IP address to be used for the copier will differ depending upon
your network. Confirm the address that you need to use in advance
with your network manager.
• Always check that DHCP server setting is "OFF" when you attempt
to input the network address.
1
Press the * / Language key.
2 Use the N and M cursor keys to move the arrow (e) to
"Default set/admin.".
3
Press the Enter key.
4 Use the numeric keys to enter your PIN code. (The factory
default code is "4850".)
5 Use the N and M cursor keys to move the arrow (e) to
"Printer setting".
6
Press the Enter key.
7 Use the N and M cursor keys to move the arrow (e) to
"DHCP server".
8 Press the Enter key.
9 If the DHCP server setting is not "OFF", use the N and M
cursor keys to move the arrow (e) to "OFF".
*The present setting is indicated by a ">" mark.
*The DHCP server default setting is "OFF" .