Kyocera Scanner/Plotter System (E) Operation Manual page 17

Chapter 3 Operating a Copier with the Scanner/Plotter System(E) Installed
5 Set the document that you want to scan.
Scanning will begin automatically when the document is
inserted. If, for any reason, it does not start automatically,
press the Start key.
NOTES
• Refer to the On-Line Manual for more detailed information on
scanning from your computer.
• Refer to the Operation Guide for your copier for more detailed
information on setting documents.
• Even if you perform the appropriate scanning procedure in your
computer, there are cases when "Ready to scan." will not be
displayed, such as if a copying operation has just been completed
at the copier or during Interrupt copying. This is because the
settings entered into the copier have yet to be cleared. In this case,
"Ready to scan." will be displayed once the Auto Clear function
engages in the copier.
• If you want the ability to start scanning right away in such cases,
turn the Scan mode ON. Refer to "G In order to give priority in the
copier to scanning documents" at right.
6 In the scan settings made in your computer, "Ready to
Scan" will be displayed again.
In this case, set the next document that you want to scan.
NOTES
• "Ready to Copy" will be displayed during Data processing.
"Ready to Scan" will be displayed after completion of Data
processing.
7 Press the Enter key to end the scanning procedure.
3-4
G In order to give priority in the copier to scanning documents
In order to give priority in the copier to scanning documents, use the
copier's operation panel and turn the Scan mode ON.
1 Press the Copier/Printer/Scanner key until the Scanner
Mode Select menu appears. The Scan mode will be turned
ON and the copier will enter the "waiting to scan" state.