Table of Contents
Advertisement
Appendices
9. Appendices
9.1 The LittleBear driver
Xi Repro System is designed to communicate with the copier through an interface
card. This card is designed specially for communication with digital copiers.
When using the Windows NT operating system to communicate with a copier through
an interface card, a device driver application (the LittleBear driver) must be loaded
onto the computer beforehand. This device driver works as the mediator between the
higher level software (Xi Repro System) and the hardware (interface card). Xi Repro
System never talks directly to the interface card. All signals are relayed through the
LittleBear driver running as part of the operating system.
The LittleBear driver (LittleBear.sys) should be installed in the WinNT\System32\drivers
directory. The LittleBear driver is automatically installed by the installation program.
To check if the LittleBear driver is running, select "Devices" from the Windows NT
control panel.
9-2
Advertisement
Table of Contents
