Setting The Default Font - Kyocera FS-9120DN Operating Manual

Chapter 3 Using the Operator Panel
KC-GL Pen Width
The KC-GL emulation mode enables you to set the pen
widths in dots, for pen numbers 1 to 8, and the KC-GL page
size.
1 Press the MENU key.
2 Press the or
appears on the message display.
Emulation
PCL 6
3 If the current emulation is other than KC-GL, press
the ENTER key. A blinking question mark (?) ap-
pears.
Emulation
?PCL 6
4 Press the or
pears.
Emulation
?KC-GL
5 Press the ENTER key.
Emulation
KC-GL
6 Press the key to move to the >KC-GL Pen Width
submenu.
>KC-GL
Pen Width
7 Press the key.
>>Pen(1) Width
01 dot(s)
8 Press the or
pen number of 1 to 8 appears.
9 When the desired pen number is displayed, press the
ENTER key.
10
To change the pen width, press the
the ENTER key. A blinking cursor appears at the
width value.
3-24
key repeatedly until Emulation
key repeatedly until KC-GL ap-
>
key repeatedly until the desired
key, then press
>>Pen(1) Width
02 dot(s)
Press the or
width in dots (00 to 99) appears. When the desired
pen width is displayed, press the ENTER key.
11 To set the KC-GL page size, press the
press the or
displayed.
12 To change the page size, press the ENTER key. A
blinking question mark (?) appears.
>KC-GL Page Set
? [SPSZ]
Press the 3 or 4 key repeatedly until the desired
page size (A2, A1, A0, B3, B2, B1, B0, and SPSZ)
appears. When selecting SPSZ, printing will be done
with the paper size specified by the PRESCRIBE
SPSZ command. For details, see
Manual
in the CD-ROM.
13 Press the ENTER key to set the page set you just se-
lected.
14 Press the MENU key. The display returns to Ready.

2.2.6 Setting the Default Font

You can select the default font for the current interface. In ad-
dition to the internal fonts, all fonts that are downloaded to
the printer memory, or fonts stored on a memory card, hard
disk, or option ROM, can be selected as the default font.
In this menu, you can also set the type and pitch for Courier
and Letter Gothic; as well as print a font list.
Selecting the Default Font
1 Press the MENU key.
2 Press the or
pears.
Font
key repeatedly until the desired pen
key until >KC-GL Page Set is
Programming
key repeatedly until Font > ap-
>
key, then