Kyocera FS-9120DN Operating Manual page 47

Chapter 3 Using the Operator Panel
3 Press the key.
4 Check that Internal is displayed and press the
key.
>Font Select
Internal
5 Press the or
pears.
>Size
012.00 point(s)
6 Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
>Size
012.00 point(s)
7 Press the or
ue of the figure where the cursor is blinking. The
font size can be set between 4 and 999.75 points, in
0.25-point increments. You can use the
to move the cursor right and left.
8 When the desired size is displayed, press the ENTER
key.
9 Press the MENU key. The message display returns to
Ready.
Setting the Character Pitch for Courier/Letter Gothic
You can set the character pitch for fixed-pitch fonts when the
default font is Courier or Letter Gothic.
1 Press the MENU key.
2 Press the or
pears.
Font
3
Press the key.
4 Check that Internal is displayed and press the
key.
>Font Select
Internal
3-26
>
key repeatedly until >Size ap-
key to increase or decrease the val-
and
key repeatedly until Font > ap-
>
>
5 Press the
pears.
>Pitch
6 Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
>Pitch
7 Press the
ue of the figure where the cursor is blinking. The
character pitch can be set between 0.44 and 99.99
characters per inch, in 0.01 character-per-inch incre-
ments. You can use the
cursor right and left.
8 When the desired size is displayed, press the ENTER
key.
9 Press the MENU key. The message display returns to
Ready.
Setting the character code set
key
You can change the character code set. Available character
code sets vary depending on the current font. (The default
character code set is IBM PC-8.)
1 Press the MENU key.
2 Press the
pears.
Font
3 Press the
4 Press the
appears.
>Code Set
IBM PC-8
5 Press the ENTER key. A blinking cursor ( ? ) ap-
pears.
>Code Set
?IBM PC-8
or key repeatedly until >Pitch ap-
10.00 cpi
10.00 cpi
or key to increase or decrease the val-
and
or key repeatedly until Font > ap-
>
key.
or key repeatedly until > Code Set
>
keys to move the