Kyocera FS-9120DN Operating Manual page 67

Chapter 3 Using the Operator Panel
1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3 Press the key. >Stitch Adjust > appears.
>Stitch Adjust >
4 Press the key. >>A4/Letter appears.
>>A4/Letter
5 Press the or
A3/Ledger.
6 When the desired paper size is displayed, press the ENTER
key. A blinking cursor (_) appears under the value.
>>A4/Letter
7 Press the or
tively, the value at the blinking cursor. Use the
and keys to move the cursor right and left.
Definable value: -057 to 057
8 When the desired value is displayed, press the
ENTER key.
Press the MENU key. The message display returns to
9
Ready.
Overriding A4 and Letter Size Difference
This selects whether to enable or disable the difference be-
tween A4 size and Letter size. Under the default setting of
Off, the paper size of the paper source is matched to the pa-
per size formatting the jobs. If these differ, a corresponding er-
ror message is displayed. When this is set to On, printing is
performed even if the actual paper size differs from the paper
size formatting the jobs.
1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3-46
key repeatedly until Paper
000
key to select A4/Letter, B4 or
000
key to increase or decrease, respec-
key repeatedly until Paper
3 Press the key.
4 Press the or
A4/LT appears.
>Override A4/LT
Off
5 Press the ENTER key. A blinking question mark (?)
appears.
>Override A4/LT
? Off
6 Select On or Off using the
7 Press the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
Customizing Paper Type
The following describes the procedure used to set a user-de-
fined paper type for the printer. Eight custom user settings
may be registered. After having been set, any of these may
be called up when setting the paper type for a paper source.
The paper weight and duplex path can be set (see
Paper Weight on page 3-47
page 3-47
) after selecting the paper type to be customized as
follows. For how to reset the customized settings, see
Resetting the Type Adjust on page 3-47
1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3 Press the key.
4 Press the or
Adjust > appears.
>Type Adjust
Custom 1
key repeatedly until >Override
or key.
Setting the
Setting the Duplex Path on
, and
.
key repeatedly until Paper
key repeatedly until >Type
>